Idiomas disponibles
Idiomas disponibles
Installation
Before the installation, note down the serial number
(Ser. Nr.) from the rating plate.The rating plate of
the appliance is on its lower casing.
ZIT64X
58 GAD D5 AU
220-240 V 50-60-Hz
ZANUSSI
Safety instructions
Warning! You must read these!
Make sure that the appliance is not damaged
because of transportation. Do not connect a damaged
appliance. If it is necessary, speak to the supplier.
Only an authorised service technician can install, connect
or repair this appliance. Use only original spare parts.
Only use built-in appliances after you assemble the
appliance into correct built-in units and work surfaces that
align to the standards.
Do not change the specifications or modify this product.
Risk of injury and damage to the appliance.
Fully obey the laws, ordinances, directives and standards
in force in the country where you use the appliance (safety
regulations, recycling regulations, electrical safety rules
etc.)!
Keep the minimum distances to other appliances and
units!
Install anti-shock protection, for example install the
drawers only with a protective floor directly below the
appliance!
Protect the cut surfaces of the worktop against moisture
with a correct sealant!
Seal the appliance to the work top with no space left with a
correct sealant!
All manuals and user guides at all-guides.com
Protect the bottom of the appliance from steam and
moisture, e.g. from a dishwasher or oven!
Do not install the appliance adjacent to doors and below
windows! If not, hot cookware can be hit off the hob when
you open doors or windows.
949 594 005 00
Induction 7,4 kW
7,4 kW
connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect plug and socket connections can
• A qualified electrician must install the clamping con-
• Use a strain relief clamp on cable.
• Use the correct mains cable of type H05BB-F Tmax
• Replace the damaged mains cable with a special cable
The appliance must have the electrical installation which
lets you disconnect the appliance from the mains at all
poles with a contact opening width of minimum 3 mm.
You must have correct isolation devices: line protecting
cut-outs, fuses (screw type fuses removed from the hold-
er), earth leakage trips and contactors.
Warning! Risk of injury from electrical current.
Carefully obey the instructions for electrical
make the terminal become too hot.
nections correctly.
90°C (or higher) for a single-phase or two-phase con-
nection.
(type H05BB-F Tmax 90°C; or higher). Speak your lo-
cal Service Force Centre.
3
