Idiomas disponibles
Idiomas disponibles
3.3. Working with the device
The device has a built-in power off memory - in the event of a power failure, the
device resumes operation with predefined parameters. In order to maintain the
best performance of the unit, it is recommended to run the system for 6 hours
before filling the inside of the unit. The device is operated using the control panel
(3). The changes currently being made are displayed on the screen (9) of the control
panel.
Caution! Opening the appliance door too often causes higher energy consumption!
3.3.1.
TURNING ON/OFF THE DEVICE
a) TURNING ON: Select and hold the "POWER" switch (5) for approximately 3
seconds.
After starting the appliance, the display (9) will show the current operating
temperature inside the refrigerator compartment.
b) TURNING OFF: Select and hold the "POWER" switch (5) for about 5 seconds.
3.3.2.
TEMPERATURE SETTINGS
a) INCREASING A VALUE: Select the "UP" adjustment button (7).
b) DECREASING THE VALUE: Select the "DOWN" adjustment button (8).
c)
A single button pressing generates a change of settings by 1°C. Selecting and
holding the adjustment button generates a continuous change in value.
d) After defining the cooling temperature value, wait until the value entered on
the display stabilizes. The changes will be stored in the system memory.
3.3.3.
SLEEP MODE
a) TURNING ON: Select and hold the "SLEEP" mode switch (6) for approximately
1 second.
b) Sleep mode generates ECO operation, i.e. the speed of the compressor and
the power consumption are reduced. The control panel illumination switches
to shades of blue.
3.3.4.
DEVICE SETTINGS
To make advanced changes to the settings, select the "SLEEP" mode button (6) for
about 5 seconds with the unit turned on. Go to defining certain parameters.
a) Choosing the voltage protection level
The device system has pre-programmed levels in the sequence H1/H2/H3.
After entering the voltage protection level, the display will show the currently
operated value (default level H2). Use the adjustment buttons (7, 8) to define
the desired voltage protection level.
After making the choice or in the event of inactivity, the system will remember
the current changes in the cache after 5 seconds.
Input voltage
12 V
Level
Shut-off level
H1
Connection
(V)
level (V)
10
11.4
