Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
b. Open the battery-compartment cover (N) by
lifting the rear of the cover and ensure that
the grip part of the chute-rotation handle (F) is
facing upward.
c. Insert the flat part of the handle into the slot of
the supporting seat.
d. Insert the front of the handle into the hole of the
guide seat and push it down until it snaps into
place.
WARNING
Turn the chute-rotation handle to make sure that
the chute rotates properly AND the discharge
opening never point toward the operator or
operator's controls.
WARNING
• Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
• Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
4. To Attach/Detach Battery Pack(Fig. 4)
Charge the battery pack(s) before first use.
NOTE: The snow blower can operate off of one or two battery packs. Using two batteries gives
you a longer run. For best performance, we recommend using two 4.0Ah KOBALT batteries
(KB 440-03) or higher capacity with this snow blower.
When not in use, 40V battery packs should be stored in an enclosed area where the
temperature will not drop below 32°F (0°C). Optimal charging temperatures are between 5°C
(41°F) and 40°C (104°F).
WARNING
If any parts are broken or missing, do not attempt to attach the battery packs to the snow
blower or operate the snow blower until the broken or missing parts are replaced. Failure to do
so could result in serious injury.
a. Open the hinged battery compartment cover by lifting the rear of the cover.
b. The snow blower features two slotted battery compartments, which accommodate on
battery pack each at the same time.
3b
3c
13
Flat Part
F
2
Supporting
Seat
Guide Seat
N
1
