Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
9.
Secure the suspension brackets (E, F, G) to the fan
housing (A) using the small machine screws (CC).
Hardware Used
CC
Small machine screw
10.
Slide the duct connector (H) into the tabs on the fan
housing (A) until the duct connector (H) snaps firmly
into place over the opening in the fan housing (A).
NOTE: Remove the protective tape on the duct
connector (H) flap.
11.
Remove the wiring box cover from the fan housing (A).
Pull the house wires through the hole in the wiring box
cover. Using the quick connectors, connect the house
wiring from the wall switch to the fan housing (A). 14 AWG
is the smallest conductor that should be used for branch
circuit wiring. Please refer to the wiring diagram on page 5
to ensure proper wire connections are made. Carefully
push the wire connections into the wiring box and reattach
the wiring box cover.
CAUTION: If the electrical wires do not match the colors
listed, you must determine what each house wire respre-
sents before connecting the wiring. You may need to
consult an electrical contractor to determine how to
make the electrical connections safely.
12.
Connect a 4 in. circular duct to the fan housing (A),
securing it with duct tape or a clamp. Vent the duct
to the outside
9
x 3
D
10
11
A
12
8
E
H
A
Quick
connector
A
C
