Idiomas disponibles
Idiomas disponibles
●
Insulate unconnected wires with vinyl tape or similar.
●
Use insulated tools when working with a power supply.
●
For EU countries:
–
The monitor is powered by a 5V external power supply and the cameras are
powered by 12V or 24V external power supply, with a properly sized fuse or
breaker (5A for 12V or 3A for 24V) mounted between the product and power
supply.
–
The external power supply used with this product shall comply with the LPS
(Limited Power Source) requirements or shall be a Power Source Class 2
(PS2) with less than 100W.
Caution
●
There are no serviceable parts in the Furrion® Vision S+ Camera System. Do not
disassemble or attempt any repairs.
●
Install external fuses/breakers as required.
Installation
●
Installation and wiring of this product require specialist skills. To ensure proper
and safe installation, please seek a specialist technician.
●
Only use supplied or recommended parts.
●
Use watertight connectors for the camera power supply cable to power source.
●
Connect the camera to a 12-24V DC circuit using 18AWG or larger cables.
●
Ensure correct polarity of DC power supply to the camera.
●
To reduce the risk of fire, connect the camera only to a circuit provided with a
maximum branch-circuit over current protection device.
●
Do not route wiring in areas that may get hot.
●
Take necessary precautions when working at elevated levels.
Use
●
Electrical appliances and overhead power lines can affect the wireless signal.
●
Do not place the monitor in a location where it might hinder field of vision while
driving.
●
Consideration should be given to any airbags when installing the monitor. Do not
place the monitor where it might hinder the airbag or become hazardous if the
airbag is deployed.
Care
●
Do not wash the vehicle with an automatic car wash or high pressure water. This
- 4 -
CCD-0005512 Rev: 03-20-22
