Idiomas disponibles
Idiomas disponibles
3. Connect the cigarette lighter
connector of the monitor power
cable to a cigarette lighter socket
of your vehicle. Connect the type-C
end to the USB-C power socket on
the back of the monitor.
NOTE: The allowed input voltage to
the monitor is 5V, only use Furrion
authorized cigarette adapter to
connect the monitor, any other
branded adapter may damage the
monitor permanently and will void
the warranty.
4. Rotate the monitor body to adjust
the visual angle as needed.
Install Doorway Security/
Rear Camera
Prepare
●
Prepare tools you may need,
including a #2 Phillips head
CCD-0005512 Rev: 03-20-22
screwdriver, sealant, insulation tape,
pencil and/or a 5/8" drill bit (needed
only when drilling a new hole).
Mount Bracket
NOTE: Skip this section if your RV is
pre-installed with a bracket for camera
installation.
IMPORTANT: Before any installation
and wiring operation, remove the key
from the ignition and isolate the 12V/24V
power source.
Always seek professional assistance if
you are unsure about the installation and
wiring operation.
1.
Determine the mounting location
on your RV. Ensure that there is
no obstacle blocking the camera
view. The recommended mounting
location is as below:
–
For rear camera position:
At the top center on the rear
of your RV and as high as
practicable (2" below the red
marker light if available).
–
For doorway camera
position:
Above the top of the door.
≥ 2˝
NOTE: The RV shown here is for
reference only. You can mount Furrion
Vision S+ products onto various types
of RV such as trailers and Class A/B/C
motorhomes.
- 11 -
