Idiomas disponibles
Idiomas disponibles
Page 8
4. Replace cap making sure o-ring is clean, lubricated with approved silicone,
and in place.
5. Turn on pump and timer switches for a minimum of 6 to 8 hours.
6. Adjust the dosage indicator according to the size of the pool. Use a test kit
to determine the chemical residual. It is recommended that the chemical
residual be checked daily for the first five days.
NOTE:
• Hot weather, high water temperature and increased bather use will
cause the pool to use more chemical. Increase the feed rate a few days
in advance when possible. The valve settings may require adjustment
depending on the conditions.
•
If the feeder does not provide enough chemical residual when using 3"
tablets, switch to 1" tablets for faster erosion and increased residual.
•
During regular maintenance, always check o-rings for damage, breaks,
swelling, etc. Replace if necessary. (see Replacement Parts list)
• Before operating this feeder, or any time the cover is removed,
completely fill feeder with water and bleed out entrapped air in any of
the lines.
To achieve optimal performance the pool must be cleaned and balanced as
follows:
• Raise chlorine level to APSP recommended levels so the water has a
sustained 1-3 ppm free chlorine level.
• Test pool chemistry and adjust pH between 7.4 and 7.6.
• Adjust total alkalinity between 80 and 120 ppm.
In order to prevent risk of serious property damage, injury or death:
• Wear eye and skin protection while maintaining or servicing this unit.
• Do not inhale fumes from the chlorinator or chemical container.
• Chlorine feeder may be under pressure. Use caution removing cover.
To avoid risk of property damage, serious injury or death, Calcium
Hypochlorite is not to be used in any form.
ENGLISH
WARNING
WARNING
TF Tablet Feeder | Installation & Operation Manual
Polaris
AutoClear
®
™
