Shredding cap
CAUTION
• The shredding cap should be
removed when using the grass trimmings collecting bag
or the rear floodgate.
• Push the cap tab to release it (F).
• Lift the cap and remove it from the rear floodgate.
Starter
• Press the switch bar towards the handle.
• Pull the starter jack line and fasten it in the ring.
Oil Replenishment
• Set the lawn mower in a flat and level area.
• Turn and remove the oil tank cap.
• Using a funnel add 16 oz SAE 10W30 motor oil for 4
cycle gas motor.
• Set back the cap and remove it to check the oil level in
the cap-measuring rod.
• When the oil in the tank reaches the right level indicated
in the rod, tighten the cap to prevent from leaking.
CAUTION
• Do not exceed the maximum oil level;
otherwise the muffler will send abundant smoke when
starting the motor.
CAUTION
• Check the oil level before each use. If
necessary add oil until it the level is between the cap rod
limits.
CAUTION
•Change oil after 50 hours operation or
every season. In dusty or dirty conditions changing oil
more often might be necessary.
Fuelling
• Set the lawn mower in a flat and level area.
• Clean and dry the area around the fuel cap.
• Remove the fuel cap.
• Using a funnel slowly fill up the tank up to the lower
part in the tank neck. Do not overfill to allow fuel
expansion and prevent leaks.
• Clean any fuel leaks.
• Cover the tank turning the cap until hearing a click.
• Before starting the motor clean any fuel leaks.
8
ENGLISH
Assembly
Fuel and oil
16 oz
F
Maximum
Minimum
