Idiomas disponibles
Idiomas disponibles
Measure the distance between the two ends of the blade and the grid with a caliper or other measuring instrument, as shown in the
2
following images, to check that the blade is completely parallel to the grid of the machine.
IMPORTANT: If the distance is not the same at both ends, the blade must be levelled so it doesn't affect the cutting process
as detailed in the following points.
Open the three latches on the grid and remove it to gain access
3
to the blade.
Loosen, without removing, the two side bolts shown in the
5
following image using fixed spanner Nº 10, and repeat the same
process with the two bolts on the opposite side.
28
=
Remove the plugs as shown in the following image, and loosen,
4
without removing, the nuts using an Allen key Nº 3 and fixed
spanner Nº 10.
The red coloured support in the following image has been
6
released and is free to move. Screwing or unscrewing the four
threaded studs on it and enabled for this purpose allow the blade
to be levelled, but before doing that, the grid must be placed as
described in the next step.
www.masterproducts.es
=
