Idiomas disponibles
Idiomas disponibles
CONNECT SOURCE WATER HOSE
1
Connect the source water hose (3/4" MGHT) to the
water inlet by screwing BOTH sides of the inlet adapter
tightly.
Note: If using a different hose, unscrew the included adapter to
connect the source water hose (3/4" BSP).
CONNECT BACKWASH HOSE
2
Connect the included light gray backwash hose to the
orange backwash outlet and route to an area where
dirty water can be discarded.
CAUTION: DO NOT DRINK WATER FROM THE
BACKWASH HOSE
3
TURN ON WATER
Turn on the water source. Make sure the preassure is
greater than 1 bar, then rotate the blue drinking water
dial to the open position.
4
RUN BACKWASH TO REMOVE AIR FROM FILTER
Switch the dark gray backwash dial to position 1 and wait
30 seconds. Then turn it to position 2, wait 30 seconds,
and continue to do so until reaching position 0. Let the
water run for up to 2 minutes while in position 0; Discard
the first batch of water.
Note: if water is extremely muddy, cycle through backwash procedure
a second time. If you notice a "sweet" taste after performing the
backwash procedure, cycle through again.
5
LIFESTRAW MAX IS NOW READY TO USE
With the backwash dial in "0" position and the drinking water dial on,
the LifeStraw Max is ready to use. Simply turn the drinking water dial to
the "close" position when done using. The system does have a pressure
regulator, but it is advisable to turn off water source when not in use for a
longer period of time.
8
FIRST TIME USE
Blue drinking water dial
in open position
Dark gray backwash dial
