Idiomas disponibles
Idiomas disponibles
SETUP | CARBON FILTER INSTALLATION
1
REMOVE TOP LID
Slide the LifeStraw Max lid locks towards the
middle of the unit to unlock. Lift the lid off of
the Max and set to the side. Lid locks do not
need to be held together while lifting the lid.
2
DISCONNECT WHITE FILTER HOUSING BRIDGE
Disconnect the top filter housing bridge (white) from the filter
cartridges by pushing the two tabs toward the center of the box
while pulling the white housing bridge upwards.
Push the two rectangular tabs
toward the center of box
3
UNSCREW AND OPEN THE TOP OF THE ADVANCED
CARBON FILTER HOUSING (GRAY)
Unscrew the top cap of the gray
carbon filter housing. Locate the
carbon filter block and remove from
wrapping.
NOTE: If you are having difficulty opening the carbon
filter housing, we recommend pulling the full gray
carbon cartridge out of the Max to unscrew the top and
install the carbon filter block.
6
Pull the white housing bridge
upwards until it is disconnected
