Idiomas disponibles
Idiomas disponibles
Start Up
Air Outlet Connection
CAUTION
• We recommend using fast couple
hoses to easily get them connected to the included
nipple. This way it can be connected and disconnected
tools fast and interchange easily.
• Remove the plastic cap covering the air inlet in the
handle base.
• Screw the included nipple to the air inlet
• Connect the air hose via the quick-connect nipple.
Rotation Direction and Torque Selection
• The direction of rotation is adjusted with the torque
selector.
• To tighten a nut or lug, push the rotation selector and
turn clockwise (F). To loosen, push the rotation selector
and turn counterclockwise (R).
• To select the torque and avoid overtightening a nut or
stud, turn the knob to the left (F) or right (R) to the desired
torque level.
• It is recommended to use the maximum torque, in case
of not having a torque wrench to verify the proper torque.
• The torque value may vary depending on the size of the
air compressor and the amount of cubic feet (CFM) of air
delivered.
Turning ON
• Turn the air compressor ON and allow it to get filled.
• Regulate the air compressor outlet pressure to 90 PSI to
110 PSI.
WARNING
• The tool operates with this pressure
range. If operating in a higher pressure range the tool
useful life will be shorter.
• Let run some air through the hose and coupling to verify
both are clean before connecting into the tool.
• Select the adequate rotation direction and torque.
• Press the trigger so that the die can rotate.
• Release the trigger to stop the die.
Operation
• Set the die in the nut or lug you want to loosen or
tighten.
• Do not try to make contact with the nut or lug with the
die moving. Do not press the trigger unless the nut or lug
is set correctly inside the die.
• Apply firm and constant pressure without forcing the
tool. Otherwise it can be damaged.
Air Inlet
Nipple
Stopper to secure
the fast couple
into the air hose
Rotation
selector
Trigger
ENGLISH
Plastic
Cap
9
