Carat CARACOUP BUK2650000 Manual De Instrucciones página 16

GB
"TRANSLATION OF
INSTRUCTIONS"
1. Purpose of this Manual
This manual is an integral part of the machine.
It was produced by CARAT to provide those
authorised to work with the machine with the
information required for its foreseeable lifespan.
Before starting to use this machine read the safety
chapter carefully.
Each machine is subjected to a series of tests and
carefully checked before leaving our factory.
CARAT is constantly striving to develop their
machines and therefore reserves the right to make
any change without prior notice. Therefore, no
claims may be made on the basis of the data and
illustrations contained in this manual.
2. Safety information
• The manufacturer accepts no responsibility
where the CARACOUP cutter is used with
any tools other than those specified in
the "RECOMMENDED
DO NOT USE WOODEN DISCS.
DO NOT USE DRY-CUTTING DISCS.
• CARACOUP is made to operate exclusively
under the conditions
"TYPE OF OPERATION
in the "TECHNICAL
• During cutting
the machine to
• CARACOUP is
with a
CAUTION!
The following steps are advisable:
• Let the motor run slowly, preventing the disc
from getting locked.
• Ensure that the piece to be cut is properly
supported by the tile clamp.
• Check before each cut that the adjustment
knobs for the cutting angle are tightened.
THE ORIGINAL
USE" paragraph.
indicated under
ALLOWED",
DATA" paragraph.
operations, allow
rest as indicated.
not made for use
continuous load.
CAUTION!
THE MACHINE IS NOT INTENDED FOR USE IN
AN EXPLOSIVE ENVIRONMENT
ALWAYS USE
DEVICES TO REDUCE THE RISKS CAUSED BY
WORK. NEVER START THE MACHINE WHEN
THE CUTTING TOOL IS MOVING; WAIT FOR IT
TO STOP.
LET OP! Con l'impiego di apparecchi elettrici
e per prevenire contatti di corrente elettrica,
ferimenti e pericolo di incendio, devono sempre
essere osservate le seguenti indicazioni di
sicurezza. Legga e osservi tali indicazioni prima
di utilizzare l'apparecchio e conservi bene le
presenti norme!
SAVE THESE INSTRUCTIONS WITH CARE.
Keep your work area perfectly clean
- Cluttered areas invite injuries.
Consider work area environment
- Don't expose tools to rain.
- Don't use tools in damp or wet locations. Keep
work area well lit.
- Don't use tools in presence of flammable liquids
or gases.
Guard against electric shocks
- Prevent body contact with grounded surfaces.
Keep children away!
- Do not let third parties contact tool or extension
cord. All visitors should be kept away from work
area.
Store your tools in a save place
- When not in use, tools should be stored in dry
and save places, out of the reach of children.
Don't force tool
- It will function better and in a safer way at the
rate for which it was intended.
Use the right tool
- Don't use low duty tools or accessories to do
the job of a heavy-duty tools. Don't use tools for
purposes not intended.
16
WARNING!
INDIVIDUAL PROTECTION