Idiomas disponibles
Idiomas disponibles
General Maintenance
1.
Do not place the calculator in hot, dusty, or damp locations.
2.
To clean the housing, use a damp cloth.
3.
Do not place anything on the housing, particularly on the head of the printer mechanism.
4.
Turn off the power switch before removing the plug from AC wall outlet.
5.
Turn the power switch off while not in use.
How to Feed the Paper Tape
1.
Plug in the calculator and turn it on.
2.
Cut or tear evenly the end of the paper roll to get a straight edge.
3.
Place the paper holder into position. (Fig. 3)
4.
Install the paper roll on the paper holder.
5.
Insert the paper end into the printer slot. (Fig. 4)
Press the Paper Feed (↑) key to feed the paper to an adequate length.
6.
Replacing the Ribbon
Your calculator is shipped with a 2-color ribbon already in place. You do not need to install or change it before using
the calculator. When you have been using your calculator for some time, however, the print will gradually become
faint, indicating that you should change the ribbon. To change the ribbon, follow these steps.
Remove the paper roll, tearing the paper at the rear of the calculator. Use the Paper Advance (↑) key to
1.
feed the remaining paper tape through the printer. Then remove the printer cover.
2.
Remove the old ribbon by pulling it upward.
3.
Install the ribbon spool with the black edge up. Unwind the ribbon from the full spool and place the full
spool on the left spindle. Thread the new ribbon along the outside of the guides and in front of the print
wheels. Place the second spool into position on the right side spindle.
4.
Rotate the spools to take up any slack. Replace the printer cover and install the paper roll.
(Replace with the Victor #7010 Ink Ribbon)
3
