Idiomas disponibles
Idiomas disponibles
USE
Select a suitable pilot bearing adaptor (8-17), this must fit in
the crankshaft locking tool or in the pilot bearing.
Select a matching centring spindle (4-6) and mount the pilot
bearing adaptor (8-17) on to the spindle thread.
Insert the spindle in the clutch hub and fix the centring
spindle in the clutch hub by turning the knurled edge
clockwise.
Centre the clutch disc with centring spindle in the crankshaft
bore (pilot bearing) and mount the automatic clutch.
In some cases, the extension (7) may have to be used.
Attention: Make sure that the clutch disc is mounted in the
proper position.
Loosen the centring spindle by turning the knurled edge anti-
clockwise and remove it from the clutch hub.
For clutches without pilot bearing, it is possible to mount the
clutch pressure plate with clutch disc on the flywheel using a
taper adaptor (2-3) or the dual disc adaptor (1).
ENVIRONMENTAL PROTECTION
Recycle undesired materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in an environmentally friendly manner.
Check with your local waste disposal authority about recycling measures.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
