Idiomas disponibles
Idiomas disponibles
A
40.1 Introduction - maintenance
Do a check of the installation each year.
Screw
Upper to lower chassis
Reference station to arm
Arm to post
Arm, support bracket and post bracket
40.2 Clean the product
WARNING:
from the power supply before any
maintenance or cleaning.
41.1 Introduction - troubleshooting
You can find all the troubleshooting messages in the
www.husqvarna.com.
120 - Maintenance
40 Maintenance
Tool
Torx 20
Torx 20
Hex key, 4 mm
Hex key, 4 mm
Disconnect the product
41 Troubleshooting
Messages menu in . You can find more information on
To reinstall the charging station on the map
Reinstall the charging station on the map if you move or
replace the charging station. You can also reinstall it if
the robotic lawn mower cannot dock or connect to the
charging station.
map objects > Charging station in the app.
1.
Select
Reinstall charging station and follow the
2.
Select
instructions.
To reinstall the reference station on the map
Reinstall the reference station on the map if you move or
replace the reference station.
map objects > Reference station in the app.
1.
Select
Reinstall reference station and follow the
2.
Select
instructions.
1.
Make sure that the post is tightly attached.
2.
Do a check of the tightening torques for all screws.
Tightening torque (Nm)
1.8
1.8
5-6
5-6
CAUTION:
Do not use a high-pressure
washer to clean the product. Do not use
solvents for cleaning.
If necessary, clean the product with a moist cloth.
1944 - 001 - 13.01.2023
