Idiomas disponibles
Idiomas disponibles
SC 35 • Operating Manual
Wear
All the blades are subject to wear and will be worn out after a given period of use. They must
then be replaced.
Worn blades could brake and cause serious damage and/or injury!
The service life of the individual components varies. Apart from wear caused by
operating use, it also depends on the type and characteristics of the material of the
surface to be treated and on the requisite power during use.
Changing parts subject to wear
Only use original Von Arx EOOD spare parts or the replacement parts indicated in
the parts lists.
REPAIRS
Only use original Von Arx EOOD spare parts or the replacement parts indicated in
the parts lists.
Alterations to the electrical wiring are prohibited!
FAULTS AND TROUBLESHOOTING
Machine does not start up
• Check the power supply to be connected to the electric network.
• Check the main switch. Replace if needed.
Low stripping capacity
• Check the edge of the blade. Worn out blade significantly decreases the stripping capacity.
Replace if needed.
Noises from the oscillating head
• Lubricate the bearings if needed.
• Check the blade holder fasteners.
The machine/blade jumps from the floor when used.
• Check the blade angle. If the blade jumps from the floor the angle may be too shallow. Using
an angle that is too steep may cause damage to the floor. Set the blade angle carefully.
Repairs
15
