CONNECTION AND OPERATION
Select the operation mode by pressing the MODE buttons. To make changes within a mode use the SET
buttons and press ENTER to confirm.
The following table shows you all the operating modes and the possible settings for each mode.
MODE 1
DMX CONTROL
Addr
AUTOMATIC
sLnd
MODES
DMX CONTROL
AUTOMATIC
MODE SETTINGS
GENERAL
SETTINGS
RESTORE
REST
DMX CONTROL
To control the device using a DMX controller:
-
Select the desired DMX operation mode: 13 or 18 channels as shown in the table above. Use the MODE
and SET button to select the number of channels and press ENTER to confirm the setting.
-
Select the DMX address to control this LED bar with a value between 1 and 512. Use the MODE and SET
button to select the DMX address and press ENTER to confirm the setting.
-
Below are the features of each channel in the different DMX operating modes:
MODE 2
VALUE
-
A001 - A512
-
Auto
-
Soun
18CH
Chnd
13CH
SH 0
SH 1
Shnd
SH 2
SH 3
SenS
00-99
YES
SEt
rPAn
no
YES
rTiL
no
OFF
LEd
on
YES
dISP
no
YES
Load
no
-
Microphone sensitivity (Sound Activation Mode ON)
(00: microphone OFF, 01: low sensitivity, 99: high sensitivity)
Reverse horizontal rotation - PAN
Normal horizontal rotation - PAN
Display turns off after 5 seconds
Information on the normal display
Inverts the information on the screen
-
- 3 -
FUNCTION
Address for DMX control
Set automatic mode (ON)
Set sound activation mode (ON)
Mode 18 DMX control channels
Mode 13 DMX control channels
Effect 1. (Automatic mode ON)
Effect 2. (Automatic mode ON)
Effect 3. (Automatic mode ON)
Effect 4. (Automatic mode ON)
Reverse vertical rotation - TIL
Normal vertical rotation - TIL
Display always on
Activate StandBy mode
No effect
Perform a check of the device
EN
