Idiomas disponibles
Idiomas disponibles
POWERING THE CLOCK
- Plug the small connector of the included USB cable into the Type-C USB
port on the back of the clock. Plug the large end into a USB power port or 5V
USB adapter (not included) and plug into a wall outlet.
- The LED display self-checks from "0000" to "9999", and then enter the
normal clock mode display.
USING THE CLOCK
1. Press [Alarm ON/OFF] button to turn on/ off the alarm, the "
"in the
lower left corner will display when the alarm is turned on.
2. When in time mode, press the [DOWM] button to toggle between the
12-hour clock and the 24-hour clock. The clock will show "PM" in the upper
left corner when in PM time.
3. In time mode, short press [ UP ] button to switch display mode, dP-1, dP-2.
SETTING THE TIME
To set the clock time, first make sure you are in time mode.
1. Press the [ SET ]button until the time is displayed.
2. Press+hold the [ SET ]button to set the time.The time hours will begin
flashing.Press the [ UP ] and [ DOWN ] buttons to adjust.
3. Press [ SET ]to save the hour setting.The minute digits will begin flashing.
Press the [ UP ] and [ DOWN ] buttons to adjust,and press [ SET ] to save. The
clock will return to its default display mode.
SETTING THE ALARM TIME
In time mode, make sure the Alarm is in off status.
1. Short press [ SET ] button enter alarm mode, display "-- --" means alarm
in off status.
2. Press [ UP ] turn on the alarm function, 12-Hours default,the "
" in the lower
left corner will display when the alarm is turned on.
4. When the alarm is turned on ,press+hold the [ SET ] button to set the alarm
time.The alarm hours will begin flashing Press the [ UP] and [ DOWN ] button
to adjust.
4
