Maintenance And Care - Ultenic T10 Manual Del Usuario

�. Download the Ultenic app from the App Store (iOS devices) or Google Play (Android devices).
�. Open the app and create a user account.
�. Tap the " + " icon to add the Robot T�� to your Ultenic account.
�. Follow the instructions in the app to set up the Wi-Fi connection.
After connecting successfully, you can control your Robot via the app. With the app, you can
select cleaning at your desired suction level, schedule cleaning, view the cleaning map, set up
"No-Mop" or "No-Go" zones, set up dust empty frequency, check the network connection
status, and access additional features.
First Cleaning and Home Mapping
After the first Auto-clean cycle the Robot will create a virtual map of your home, viewable in the
Ultenic app. Using that map you can define Areas and set Virtual Boundaries. Those Areas and
Boundaries can then be used in any of your cleaning cycles and schedules (eg avoid the "Baby
Room" during a daytime clean, mop ONLY the "Kitchen").
Use the included remote control, or the Ultenic APP to control your preferred cleaning method.
Once you have chosen your preferred cleaning method, the Robot will start cleaning and will
continue until it has covered the entire cleaning area, or until the battery is low and needs to be
re-charged. Once cleaning is finished, the Robot will automatically return back to the Auto Empty
Base to empty the dustbin. If a cleaning session was interrupted due to low battery, it will automati-
cally resume cleaning once the power has been sufficiently restored.
Cleaning Modes
Auto Clean - The Robot will automatically clean your floor until it has covered the entire surface.
Once cleaning is finished or the battery needs to be re-charged, the Robot will automatically return
back to the Auto Empty Base to empty the Robot's dustbin and charge or resume cleaning.
Area Clean - Create customizable areas on your floor-plan within the Ultenic App for your Robot to
specifically clean or avoid.
Spot Clean - The Robot will focus on a specific spot you desire to have cleaned thoroughly. First,
use the manual navigation control on the remote (or in the app) to guide the Robot to the desired
area. Then, choose Spot Clean mode.
Mopping - Attach the water tank attachment to the dustbin from the rear of the Robot. Choose
Mopping mode in the Ultenic App or the included remote and the Robot will automatically mop the
surface and return to the Auto Empty Base once complete.
Manual Control - Using the Ultenic App or the included remote, you can manually control where
the Robot goes.

Maintenance and Care

Your Robot is designed to be used regularly. As with most floor care devices, regular use may cause
build-up around brushes, in debris compartments and near filters. We recommend performing
regular maintenance, as outlined in the following pages, to keep your Robot running at optimal
performance.
�. Recommended Care/ Replacement Frequency
PART CARE FREQUENCY
Rolling brush Once per week
Side brush Once per week
Filters Once per week
Sensors Once per month
Charging contacts Once per month
Once per month
Omnidirectional wheel
�. Maintaining Side Brush
Use a Philips screwdriver to unscrew
the side brush screw and remove the
side brush.
Note:
It is recommended to replace the side brush every �-� months depending on use.
�. Maintaining Rolling Brush
Pinch the left and right tabs on the
rolling brush cover. Lift and remove the
cover.
REPLACEMENT FREQUENCY
Every 6-12 months
Every 3-6 months
Every 2 months
⸺
⸺
⸺
Remove dirt and debris and reinstall
using Philips screwdriver.
Remove the main brush and clean with
included cleaning tool as seen in the
figure below.