Casselin CFOG4 Manual De Instrucciones página 21

EN
1) Unscrew the nozzle from the main burner and replace it with the nozzle indicated in the table
„TECHNICAL CHARACTERISTICS".
2) Adjust the air supply according to the type of gas according to the table „TECHNICAL
CHARACTERISTICS".
Adjust the pilot burner by loosening the safety screw with a spanner, then unscrew the pilot burner nozzle (fi
g.3, note 1) with the spring (fi g.3, note 2.3) and replace it with a nozzle corresponding to the type of gas
used, respecting the instructions in the table. Tighten the nozzle cover with a wrench and set the "eco" mode,
see text below.
Important :
After adjusting the appliance to another type of gas, it is necessary to change the gas indicated on the
technical plate located in a visible place on the back of the appliance.
Flame adjustment at reduced „ECONOMY" performance
Flame with reduced „ECONOMY" performance, can be adjusted with the screw placed in the valve body
(Note. 1, Fig. 5) placed next to the valve stem
To adjust, proceed as follows:
- Remove the control button (Note. 1, fi g 4). Pulling towards you
- Adjust the flame through the hole with a flat screwdriver
Access to
view the
flame