DenMat PeriOptics Firefly Instrucciones De Uso página 4

Operating Instructions
1. Charging light pod batteries
a. Plug the power adapter (1) into a power outlet
and connect to battery charger unit (4).
b. A single blue light in the center of the charger
will indicate power to the charger.
c. Place a light pod (3) into the charger unit (4).
Make sure the lens is facing up to engage
charger terminals.
d. When the light pod(s) is inserted into the
charger, the appropriate charger indicator
lights will illuminate.
e. When all four charger lights are illuminated, the light pod is fully charged.
2. Mounting the light
Attach the Firefly mount to your loupes.
Universal Mount attachment to eyeglass frames
Open the clip and slide down over the top of the nose bridge. The padded arms of the clip
should grasp each side of the eyeglass lenses. Tighten thumb screw to secure clip
to frame.
There are many mount options for all glasses styles.
Please contact DenMat Customer Care with mount options and questions.
3. Clip the Firefly light pod to its mount
a. Remove the fully charged light pod from the Firefly charger.
b. Place the rear of the light pod on the mount. It will magnetically "click" into place.
4. Turn on light pod by rotating pod
Rotating the light pod on its mount will cycle through off-high power-low power-off settings.
5. Adjust the direction of the LED beam
To adjust the tension or the lamp head position, use the supplied phillips screwdriver to
tighten or loosen the two small link screws as needed.
6. Removing the Firefly light pod from the mount
To remove the firefly light pod from the magnetic mount twist the light to break the
magnetic seal, then pull to the left or right of the loupes and NOT up or down.
2
110v / 120v
denmat.com
1
4
3
English