Hiltron security XR Serie Manual De Instrucciones página 4

XR200 - XR Series transmitter with NC line input
INSERTING OR REPLACING THE BATTERY
Before inserting the battery, press and hold the centre button for 5 seconds; then release it and insert the new battery,
checking that the two LEDs light-up instantaneously. If not, repeat the process keeping the right button pressed for a little
longer.
Make sure that the rigid antenna wire, located on the left side of the circuit, is positioned in parallel to the battery and that
the battery wire does not interfere with the tamper spring, before replacing the cover.
CONFIGURATION
Device configuration consists of simply entering a three-digit code for each area, followed by the system code
programmed at the central terminal.
To configure the transmitter:
Press and hold the two buttons simultaneously.
When both LEDs light up, release the buttons.
Enter the area code using the left button for one (1) and the right for zero (0).
Follow the programming procedure, depending of the central XR used:
Installed with XR100
000 - Zone 2
100 - Zone 3
Installed with XR1600
000 - Zone 0
001 - Zone 1
010 - Zone 2
011 - Zone 3
100 - Zone 4
101 - Zone 5
110 - Zone 6
111 - Zone 7
Then enter the 18-digit terminal code, checking that the green LED lights up for one (left
button) and the red LED for zero (right button).
If the configuration is successful, the two LEDs will light up instantaneously.
If the code transmission is interrupted for more than 30 seconds, the XR200 will automatically exit configuration without
changing any of the codes.
Note: if you enter a terminal code containing a sequence of all ones or all zeros, the XR200 will produce an error signal
and both LEDs will flash simultaneously to indicate an error.
LOW BATTERY WARNING
Each time the contact is opened:
Green LED: working correctly
Red LED: battery empty
4 4
XR200
Installed with PROTEC4GSM/8GSM/TM800GSM
000 = zone 1
100 = zone 2
010 = zone 3
110 = zone 4
001 = zone 5
101 = zone 6
011 = zone 7
111 = zone 8
Installed with XR500
ZONE 2 : 000
ZONE 3 : 100
ZONE 4 : 010
2S
security
"1" "0"