Activation; Start-Up - PAJ GPS VEHICLE FINDER 4G 2.0 Manual De Instrucciones

2.3 Activation

NOTE!
Note! In order to proceed with activation you
will need the device ID. Please write this number
down before installing your FINDER.
In order to start using your VEHICLE Finder 2.0, first you will
have to activate it online. Please enter the following link:
www.start.finder-portal.com
...or simply scan the shown QR code
and follow the instructions.
2.4 Start up
The moment you successfully activate your device; you can start
your FINDER. Please observe the following points before con-
necting the device to the vehicle battery:
SIM card is already in the VEHICLE Finder 2.0
The VEHICLE Finder 2.0 should not be attached to fuel
lines or other combustible components.
No other components of your vehicle should be damaged by
the attachment.
When installing the VEHICLE Finder 2.0 and therefore con-
necting it to your vehicle's battery, beware that in order to sup-
ply your device with sufficient power, your vehicle's battery
may discharge. If the battery is intact and you are regularly
on the road, this should not happen as your vehicle's battery
will be recharged constantly while driving. If this were not the
case, check whether your battery is equipped with protection
against battery discharge before connecting your VEHICLE
Finder 2.0 and retrofit it if necessary. In standby mode, the
Finder will need from 10 to 20 mAh approximately.
Please always observe the manufacturer's specifications
for your vehicle. Compensation claims due to incorrect
connections are hereby excluded.
23