10
1. Sawhorse in folded/carry position.
2. By the "
" icon press the release button and pull down the legs until they are fully extended.
3. Separate the legs and push the crossbar downwards.
4. Next press the lock button by the "
5. The legs can be adjusted in steps of 2.54 cm. To extend, pull down the legs until the latch is in the
desired position. To retract, press the locking button, pull down slightly and subsequently push up
the leg.
6. To support sheet timber for cutting fold down the support brackets on the side of the legs.
7. Two trestles can be used to create a work table, simply insert two 45x95mm sections of timber into
the support brackets between two trestles and lay a sheet of timber on top.
Please note the maximum weight loading the makeshift table can take will depend on the strength
of the timber being used for the supports and the table top.
WARNING:
To close the sawhorse, repeat these steps but in reverse order: first close leg "
and then leg "
Assembly
Assemblage
Asamblare
Montaje
".
Montaż
Montagem
" icon and lower the second leg until it locks into position.
"
