AnyTone METIS Manual De Instrucciones página 13

4. HOW TO USE THIS RADIO
• CTCSS/DCS Setting (long press)
(1) Long press
(2) Short press
C: stands for CTCSS tone
D: stands for DCS code
(3) Short press
CTCSS tones from 001 to 038 and 104 DCS codes from 001 to 104.
(4) Long press
4.7 EMG
• Emergency Channel (short press)
(1) Short press
(2) Short press
(3) Short press
4.8. VOX
• VOX (short press)
Short press key to enable/disable the VOX function. The LCD displays " " when the
VOX function is enabled.
• VOX Setting (long press)
(1) Long press
(2) Short press
LE: stands for sensitivity level. Allows the adjustment of the microphone for an
optimum transmission quality. Adjustable level from 1 (high sensibility) to 9 (low
sensibility)
TI: stands for delay time.allows avoiding the sudden cut of the transmission by
adding a delay at the end of speaking. The level is adjustable from 1 (short time
delay) to 9 (long time delay).
(3) Short press
(4) Long press
4.9. Norms Control
(1) Hold key to power on radio until LCD displays the norms.
(2) Press or
(3) Power off and power on again
4.10. Install external speaker
Choose a 8Ω external speaker with 3.5mm mono connector.
4.11. Resume Factory Default
(1) Hold press
work finish.
(2) TAll channel and function setting will resume factory default after above operation.
key to enter the CTCSS/DCS function setting, "
key to select CTCSS tone or DCS code.
o key to set desired CTCSS tone or DCS code. There are 38
key to store and exit setting.
key to choose CH9, the channel number flashes.
key again to choose CH19, the channel number flashes.
key third time to return to last normal channel.
key enter the VOX function setting, " " flashes in the LCD.
key to choose wanted setting.
or key to set desired level.
key to store and exit setting.
key to choose wanted norms.
key key to power on radio, until the LCD displays "
" flashes in the LCD
", the resume