Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

PREPARING THE CHARGER FOR USE
USING THE XS CHARGER ON A TABLETOP
The XS Truckmount Charger can be used as a stand-alone
device on a tabletop. To use in this manner, install the
optional AC adapter as pictured in Figure 1.
INSTALLING THE XS CHARGER IN A VEHICLE:
Installation
The XS Charger is designed to be mounted on any convenient
flat-panel surface in a vehicle. When installed and used in
accordance with these instructions, the unit is designed to
comply with NFPA 1901-14.1.11.2 and EN1846-2
(see caution for proper installation).
Location
Select a conveniently located, flat-panel surface of sufficient size to
accommodate the unit. The unit can be mounted in any orientation
and will comply with NFPA 1901-14.1.11.2 and EN1846-2. The XS
Charger attaches through with five (5) #10 Hex Head Drilling Screws
that are also provided with the unit . Allow 6-inch clearance above the
charger to remove TXS.
NOTE
The XS Charger should be connected to an un-switched
fused circuit such as the apparatus battery that con-
tinues to provide power when the vehicle is not in use.
Wiring the XS Charger to a switched circuit or through
a relay may result in discharged imager batteries if the
vehicle is left idle for periods of more than a few days
at a time.
Item
Requirements
Polarity
Red: Positive +
Black: Negative -
Input voltage
12V - 24V
Input current
2A @ 12V
Minimum gauge
18 AWG /
DO NOT wire the XS Charger to a third-party apparatus battery charger!
Failure to comply may result in improper function of the XS Charger.
ø
1 mm²
WARNING
BULLARD XS CHARGER
INSTRUCTION MANUAL
6 in/15 cm
w w w . b u l l a r d . c o m
6"
Figure 1
Figure 2
1
loading

Resumen de contenidos para Bullard XS Serie

  • Página 5 BULLARD XS CHARGER MANUAL DE INSTRUCCIONES PREPARAR EL CARGADOR PARA EL USO USO DEL XS CHARGER SOBRE UNA SUPERFICIE El XS Truckmount Charger se puede usar como un dispositivo autónomo sobre una superficie. Para esto, instale el adaptador opcional CA como se describe en la Figura 1.
  • Página 6: Funcionamiento

    BULLARD XS CHARGER MANUAL DE INSTRUCCIONES INSTALACIÓN DEL CABLE EN EL CARGADOR Figura 3 MARCACIÓN Y PERFORADO DEL PANE Marque la ubicación de los cinco orificios avellanados usando la plantilla como guía. Asegúrese de que no haya bordes ni rebabas cortantes que puedan dañar el aislamiento de los cables...
  • Página 7 Las correas de goma están diseñadas para poder cambiarse. Para re- emplazar las correas de goma, desatornille con un destornillador Philips Cargue únicamente usando el Bullard XS Charger o el adaptador o de cabeza plana, tire del tornillo de cabeza hexagonal y del cilindro de USB suministrado por Bullard.