First Start-Up - sauermann SI-CA 030 Guia De Inicio Rapido

2 Analyzers description
1. Min-DIN connection for CO and CO
probe
2. Thermocouple connection for air
7
temperature
1
2
3. Thermocouple connection for flue gas
3
temperature
4
5
6
4. P- connection
5. P+ connection
6. Gas connection
7. USB connection
7
1
2
3
3 Operating temperature, protection of the instruments and information about storage
4
• Operating temperature: from -5 to 45 °C (23 to 113 °F)
5
6
• Protection: IP42
If the instrument is stored outside the operating temperature (for example in a van, a
warehouse,...) please let the analyzer acclimate to room temperature for at least 15 minutes
before starting and operating the analyzer.
If the ambient temperature is lower than 10 °C (50 °F), the analyzer should be acclimated
to ambient temperature before performing measurements.
4

First start-up

DO NOT insert the gas probe in the flue/chimney/stack.
Keep pressed for 3 seconds to turn on the analyzer.
Press Down key to
Select your country
go to "Start" then
pressing Up and
press OK.
Down keys and
validate with OK.
2
Select your
Set the date pressing
language pressing
OK on each line, use
Up and Down keys
Up and Down keys to
and validate with
select the correct item
OK.
and validate with OK
then go to "Next".
Set the time pressing
Set your time zone
OK on each line, use
pressing OK on each
Up and Down keys
line, use Up and
to select the correct
Down keys to select
item and validate
the correct item and
with OK then go to
validate with OK
"Next".
then go to "Next".
The probe can be inserted in the chimney.
The analyzer displays the measurements.
5 ON / OFF
During autozero, DO NOT insert the gas probe in the chimney.
Keep pressed for 3 seconds to turn on the analyzer.
Once the autozero is finished, insert the gas probe in the chimney
and gas measurments are displayed.
Keep pressed for 3 seconds to turn off the analyzer.
Before powering off, disconnect hoses from the analyzer and
empty and dry the water trap.
6 Stop / Restart the Pump
Press "Main Menu" key.
Press OK on "Pump" line to activate or
deactivate the pump.
Select if you want Autozero is in progess.
your pump turned
ON or OFF after
Auto-Zero pressing
OK then go to
"Save".