How To Use - Carlo Cracco MasterPRO BGMP-9143 Manual De Instrucciones

EN

HOW TO USE

Before Your First Use
Ensure that it is unplugged from the wall outlet. Carefully unpack the slicer and accessories. Remove
all packaging materials. Wash the following removable parts; FOOD PUSHER and CUTTING
BLADE, in warm, soapy water to remove any dust that may have accumulated during packaging. Do
not immerse the MOTOR BASE, cord or plug in water. Wipe the MOTOR BASE with a damp cloth.
CAUTION: The CUTTING BLADE is very sharp. Use care when handling.
Assembly:
1. Place assembled slicer on a flat, dry, level surface. Position slicer in front of you with the THICK-
NESS CONTROL KNOB on your left and the FOOD PUSHER
2. Make sure the ON/OFF SWITCH IS in the Off position.
3. Ensure that the blade is properly assembled using the 3 BLADE SCREWS, BLADE COVER, AND
BLADE LOCKING SCREW. Ensure all screws are present & tightened
4. Position the FOOD PUSHER on the back edge of the FOOD CARRIAGE.
5. Make sure food to be sliced fits on FOOD CARRIAGE without going over top of blade.
6. Place your hand on the curved ridge edge of the FOOD PUSHER, ensuring that your thumb is
behind the thumb guard.
7. Set the THICKNESS CONTROL KNOB to your desired thickness.
on your right.
11
HOW TO USE
1. Plug the cord into a 120 Volt AC outlet.
2. Press ON/OFF SWITCH to the On position to start the slicer
3. Allow slicer to run for 30 seconds to warm up.
4. Grasp the FOOD PUSHER with right hand, keeping your thumb protected behind the FOOD
PUSHER. Apply slow even pressure for best slicing results.
5. Apply pressure on the FOOD PUSHER towards your food to hold in place.
6. Move the FOOD PUSHER towards the blade. Move back and forth in a slow steady rhythm.
7. You can lubricate the food carriage rod with a little vegetable oil to allow the food carriage to glide
easier
Caution: To avoid a laceration hazard never attempt to slice food without using the FOOD PUSHER
and/or FOOD CARRIAGE.
8. Do not run the slicer continuously for more than 10 minutes to avoid overheating the motor.
9. When finished slicing, switch the ON/OFF button to Off position to stop the blade from turning.
10. Unplug from outlet.
11. When finished using your slicer, or when storing your slicer always set the THICKNESS
CONTROL KNOB to "0".
12
EN