Probuilder 32891 Manual De Instrucciones página 62

If the blade is not perpendicular to the saw
bench, adjust the saw arm as follows:
Loosen the lock knob for the bevel angle
(16).
E D
C
Loosen the lock screw (A) using the spanner
provided. Loosen the counter-nut (B) and
turn the adjustment screw (C) until the saw
blade is perpendicular to the saw table.
Retighten the counter-nut.
Loosen the screw holding the arrow on the
scale for bevel angle (24) and adjust the
arrow so it points to 0°. Retighten the screw.
If you have an angle of 45 degrees, you can
adjust the 45° bevel angle on the other
adjustment screw (D) and counter-nut (E) in
the same way.
62
A
br
B
Calibrating the mitre angle
The saw arm must be locked securely in its
lowest position.
Loosen the lock knob for the mitre angle (10).
Push the release knob (11) up, and turn the
arm (9) until the indicator lines up with 0°
on the scale for the mitre angle. Release the
release knob (11) and retighten the lock
knob (10).
Loosen the lock knob for the bevel angle
(16). Adjust the saw arm to a bevel angle of
0° so the saw blade is perpendicular to the
saw bench. Tighten the lock knob for the
bevel angle.
F
F
Loosen the screws 2 (F) holding the guide (6)
on one side securely to the base.
Place a try square between the blade
and the guide, and turn the guide until is
perpendicular to the saw blade.
Retighten the screws (F).
Adjust the guide on the other side in the
same way.
Loosen the screw holding the arrow (G) on
the scale for mitre angle and adjust the arrow
so it points to 0°.
Retighten the screw.