Husqvarna R112iC Manual De Usuario página 25

Problem
The display does not come on
when the power switch is set to
"1".
All LED lights on the display are
flashing slow in sync.
All LED lights on the display has
a solid light for more than 3 sec-
onds.
The cutting deck motors does not
start.
The battery does not charge.
There is vibration in the product.
1263 - 006 - 27.04.2022
Cause
The battery is not charged.
Blown 5 A fuse.
The vehicle control unit (VCU) or
its connections are defective.
The power switch is defective.
The control panel is broken.
The vehicle control unit (VCU) or
its connections are defective.
Defective internal connection be-
tween the control units in the
product.
The 2 cables to the cutting deck
are not connected correctly.
The cutting deck is full of grass.
The battery is not charged.
The lock to the cutting deck is not
engaged or the switch to the lock
is defective.
The cutting deck is not in mow
position.
The cutting deck motors are de-
fective.
The controls for the cutting deck
motors are defective.
The battery charger is not con-
nected correctly.
The battery charger is defective.
The battery is defective.
The battery temperature is above
45°C.
The battery temperature is to
low.
The blades are loose.
One or more of the blades are
not balanced.
The motor is loose.
Action
Charge the battery.
Change the fuse.
Speak to an approved service workshop.
Speak to an approved service workshop.
Speak to an approved service workshop.
Connect the cutting deck to the product, refer
to To attach the cutting deck on page 15 .
Clean the cutting deck, refer to
the cutting deck on page 16 .
Charge the battery.
Attach the cutting deck correctly, refer to
attach the cutting deck on page 15 .
Speak to an approved service workshop if
the problem stays.
Move the cutting deck to mow postion, refer
To lift and lower the cutting deck on page
to
18 .
Speak to an approved service workshop.
To charge the battery on page 17 .
Refer to
Change battery charger.
Speak to an approved service workshop.
Let the battery cool down for a while.
Move the product to a location with the ap-
proved temperature for the batteries. Refer to
Storage on page 27 .
To examine the blades on page 23 .
Refer to
To examine the blades on page 23 .
Refer to
Speak to an approved service workshop.
To remove
To
25