Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. INSTALLATION
5.1 Built-in installation of single
appliance
Once the front panel has been adjusted, check
that the gasket has been repositioned correctly
to assure the door/drawer are closing cor-
rectly and avoid operational errors of the unit.
For a built-in installation, to close gaps between the
appliance and the adjacent cabinets, special side
profiles (installed) and trim covers (taped to back
of appliance) are provided. Side profiles are used for
fixing the appliance to the niche cabinet and can be
shimmed from the side of the appliance in order to
match the niche width. (Remove screws holding trim to
side of appliance and place washers between profile
and appliance and replace screws for example).
Operate as follows:
>
Push the appliance into the installation niche
>
If the unit is to be installed inside a niche or within
an enclosed structure, it is not necessary to design a
ventilation shaft at the back of the niche as European
models come with a top ventilation cap which accom-
modates sufficient ventilation even though it is behind
the overlay panel.
Ensure panels are mounted (BI Series) prior to pushing
the appliance all the way into the niche as the panel
mounting procedure requires additional height clea-
rance than the niche provides. If for some reason the
top ventilation cap has been removed - a minimum
5mm gap must be provided at the top / back of the ca-
binetry to allow warm air to escape.
1
A plastic connecting brackets
B Profile trim cover
>
Check the levelling of the appliance, adjusting its feet
and wheels to correct it.
>
Using the screws provided, secure the appliance to
the adjacent cabinets through the holes on the profile
side trims
To make this operation easier keep the door and the
drawer open. It may be necessary to hold the door at an
approximate 70 degree angle to get the easiest access
on the hinge side profile with a screwdriver.
>
Install the profile trim covers: mate with the face of
the appliance and the top of the niche then slide late-
rally over the profile trims. It will be necessary to press
firmly or use a block and mallet to completely lock the
trims into place until a 'click' is heard. Take care not to
damage the trims. Ensure that the full installation is
satisfactory prior to installing the profile trim covers
as it is very difficult to remove them wi-thout
damaging them after installation
[ 1
].
SIDE PROFILES MOUNTING
Appliance
A
B
Wall or furniture
[ 2
].
[ 3
2
3
B
EN
].
15
Tabla de contenido
