Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6 INSTALLATION (PAGE 4)
Warning - danger!
All installation and assembly operations must be performed with the
appliance disconnected from the mains power supply.
The assembly sequence is illustrated on page 4.
6.1
Assembly
When unpacking, check for any missing accessories or damage
to the contents. If damage caused in transit is found, notify your
dealer at once.
Lift the cover with the motor (A10) off the appliance, releasing
the catches (A6) and take out the accessories supplied, checking
that the filter (B1) and the filter (B2) are fitted correctly.
If filter (B2) has not been fitted, fit it so that it covers filter
(B1) completely.
See fig. 2
The assembly sequence is illustrated on page 4.
6.2
Fitting the accessories
Connect the hose (B3) to the intake (A2) or the blower outlet
(A3) depending on the type of operation required.
See fig. 3
Then complete the sequence by connecting the hose (B3) to
the tube (B5).
See fig. 3
6.3
Electrical connection
Warning - danger!
Check that the electricity supply voltage and frequency
(V/Hz) correspond to those specified on the data plate See fig.5
6.3.1 Use of extension cables
Use cables and plugs with "IPX4" protection level.
The cross-section of the extension cable should be
proportionate to its length; the longer it is, the
greater its cross-section should be.
7 INFORMATION ON USE OF THE APPLIANCE (PAGE 5)
7.1
Controls
- Starter device (A1). See fig. 6.
Set the starter device switch on (ON/I).
If there is a pilot light on the starter device, it should light
up. Set the starter device switch on (OFF/0) to stop the
appliance. If there is a pilot light on the starter device, it
should go out.
Warning - danger!
During operation the appliance must be positioned as shown on a
firm, stable surface. See fig. 6.
7.2
Start-up
7.2.1 Suction. See fig. 7.
Only work with filter (B1) and filter (B2) dry!
Before use, check the filter (B1) and filter (B2) for
damage and replace them if necessary. Connect
the relevant accessory before sucking in cold ash.
See fig. 7.
When sucking in ash, hold the nozzle (B5) at least 1
cm above the surface of the material. See fig. 8.
94911_E12.indb 25
19
English
19/5/7 下午4:50
Tabla de contenido
