Limb Tree Branches; Maintenance; Adjust The Chain Tension; Sharpen The Cutters - GreenWorks Pro PS80L01 Manual Del Operador

EN
8.5

LIMB TREE BRANCHES

Limbing is to remove the branches from a fallen tree.
1. Keep the larger lower branches to hold the log off the
ground.
2. Remove the small limbs in one cut.
3. Limb the branches with tension from the bottom to up.
4. Keep the larger lower branches as a support until the log
is limbed.
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9.1

ADJUST THE CHAIN TENSION

Wear protective gloves if you touch the chain, bar or areas
around the chain.
1. Loosen the chain cover (14) by turning the chain cover
knob (8) counterclockwise.
A
A
CAUTION
CAUTION
WARNING
CAUTION
8
14
English
It is not necessary to remove the chain cover to adjust the
chain tension.
2. Turn the chain tension screw behind the bar and chain
clockwise to increase the chain tension.
3. Turn the chain tension screw counterclockwise to
decrease the chain tension.
4. When the chain is at the wanted tension, tighten the chain
cover.
9.2

SHARPEN THE CUTTERS

Sharpen the cutters if chain does not go into wood easily.
We recommend that a service center, which has an electric
sharpener, perform important sharpening work.
1. Clamp Bar.
2. Sharpen the cutters corner with a 5/32 in. (4 mm)
diameter round file .
3. Sharpen the top plate, side plate and depth gauge with a
flat file.
10
NOTE
NOTE