Install The Battery Pack; Remove The Battery Pack; Operation; Examine The Chain Oil - GreenWorks CSF404 Manual Del Operador

5. Tighten the oil cap.
6. The whole oil tank will last for approximately 20- 40
minutes.
IMPORTANT
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
8.3

INSTALL THE BATTERY PACK

WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.4

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (18).
2. Remove the battery pack from the machine.
9

OPERATION

NOTE
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
IMPORTANT
Examine the chain tension before each use.
9.1

EXAMINE THE CHAIN OIL

NOTE
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
English
2. Add oil if necessary.
9.2

HOLD THE MACHINE

1. Hold the chainsaw with your right hand on the rear
handle and left hand on the front handle.
2. Hold the handles with the thumbs and the fingers
around them.
3. Make sure that your left hand holds the front handle
and your thumb is below the handle.
9.3

START THE MACHINE

1. Press the lock-out button (4).
2. Press the trigger (5) while you hold the lock-out
button.
3. Release the lock-out button.
The chain brake must be disengaged for the chain
saw to start. Activate the brake by moving the front
hand guard forwards.
9.4

STOP THE MACHINE

1. Release the trigger to stop the machine.
9.5

OPERATE THE CHAIN BRAKE

Make sure that your hands are on the handles at all
times.
9
IMPORTANT
WARNING
EN