ROTOR INspider ROT117 Manual De Usuario página 54

Can I replace the battery?
ROTOR INspider uses a Lithium (Li-ion) battery. It has
3.7 V nominal tension and 290 mAh capacity. It can
complete 300 charges without damage, and a
complete charge lasts for 220 hours of use. This
means that one single battery should last for 66,000
hours without damage, enough time not to require
replacement during the complete lifetime of the
power meter. In case battery replacement is needed
you should contact your ROTOR dealer and they will
assist you.
If I usually connect to the
the computer, is the battery life still 220 hours?
If fast mode (or TORQUE 360) is active (only possible
with the or the ROTOR Power app),
User Software
battery consumption is higher due to the higher
frequency of data emission required to represent the
graph. Always disconnect the power meter when
closing the program to make sure fast mode is off.
How can I clean my INspider? Are they waterproof?
INspider power meter is waterproof. It has been
tested under and has succesfully passed IPX7 level.
However, it is not recommended to clean your power
meter with high pressure and avoid direct water
impact on the seals. Do not use solvents or
degreasers; they can damage some power meter
elements.
How can I update the firmware of my power meter?
How often do I have to update the firmware?
ROTOR sometimes offers firmware updates with
improvements.
The update process is wireless; to complete this you
will need to download the
ROTOR website.
You can complete the process via ANT+ , for
which you will need an ANT+ dongle, or via
Bluetooth® Smart.
54 Frequently asked questions
running on
User Software
from the
User Software
TM
TM
What happens if there is an error while updating the
firmware?
If any error occurs during the updating process, you need
to try the update again until it successfully finishes. If the
update process begins and the program detects any
problem, the process will restart a maximum of 5 times
before cancelling the update.
If the firmware update is done via ANT+ , it is recommended
TM
to place the ANT+ dongle as close to the cranks as
possible for better radio signal reception.
TM