Button Lock - Ruwido s 2 universal Manual De Instrucciones

All manuals and user guides at all-guides.com
2) Use the number buttons to enter the code
twice again.
3) Push and count the number of times the Signal LED fl ashes; this is the fi rst
1
number.
4) Push and count the number of times the Signal LED fl ashes; this is the second
2
number.
5) Push and count the number of times the Signal LED fl ashes; this is the third
3
number.
6) Push and count the number of times the Signal LED fl ashes; this is the fourth
4
number.
Note : The Signal LED does not fl ash if the number is 0. The steps 3 to 6 can
be carried out in any order and as many times as may be required.
Operating the volume function on the TV set or satellite receiver
or the DVB-T (Freeview)/cable-box (STB)
As standard, the volume and mute functions are operated from the satellite receiver or
DVB-T (Freeview)/cable-box (STB).
If you wish to operate these functions on the TV set, then please carry out the
following steps.
1) Press and hold the TV Standby button (
2) Use the number buttons to enter the code
again.
If you wish to operate the volume functions on the satellite receiver or the DVB-T
(Freeview)/cable-box (STB) again, carry out the following steps.
1) Press and hold the TV Standby button (
2) Use the number buttons to enter the code
again.

Button lock

You have the facility for deactivation of individual or not-required functions on the s_2
remote control.
1) Press and hold the STB Standby button (
twice.
2) Use the number buttons to enter the code
again.
3) Push all the buttons, one after the other, whose functions that you wish to block.
4) Push the STB Standby button (
Note : The numbers and the Standby button ( ) cannot be blocked.
Note : If you want to reverse the key lock again, you need to fully reset the
remote control. See function "Deleting settings (reset)".
Code blocking
You can activate the code block to prevent inadvertent programming of the s_2.
1) Press and hold the TV Standby button (
2) Use the number buttons to enter the code
again.
3) The remote control is now blocked for re-programming
Note : The fact that the code block is activated can be seen by the fact that the
Signal LED ( ) on the s_2 remote control fl ashes once long instead of twice short.
Note : Please repeat the steps 1 to 3 if you wish to de-activate the code block.
BA s_2 Universal, Innenteil, 105x210 mm CS4.indd 16 BA s_2 Universal, Innenteil, 105x210 mm CS4.indd 16
. The Signal LED ( ) fl ashes
0 0 0 2
) until the signal LED ( ) fl ashes twice.
tv
. The Signal LED fl ashes twice
0 0 0 4
) until the signal LED ( ) fl ashes twice.
tv
. The Signal LED fl ashes twice
0 0 0 5
) until the signal LED ( ) fl ashes
stb
. The Signal LED fl ashes twice
0 0 0 6
) to confi rm.
stb
) until the signal LED ( ) fl ashes twice.
tv
. The Signal LED fl ashes twice
0 0 0 7
16
11.06.2012 12:53:10 11.06.2012 12:53:10