G-Systems GSE Light timer Manual Del Usuario página 19

User Manual GSE Light controller
Thank you for purchasing GSE Light controller. The Light controller is a
2-channel light timer to controll your digital-ballast and LED-Lights
controlled by 0-10V or PWM signal. You have several features like:
Temperature surveillance avoids overheating, day counter, sunset/sunrise
etc.
The warranty is only valid with a warranty card containing sales date
and stamp from the place of purchase. Or electronic registered warranty at
http://g-systems.eu/warranty. If this is not so, please return immediately
to the sales office!
1. LED overheat (Sensor B)
2. LED overheat (Sensor A)
3. ENTER button
4. Power LED
5. SAVE/EXIT button
6. UP button
7. Display
8. DOWN button
9. Connector RJ45 Temperature Sensor A
10. Connector RJ45 Temperature Sensor B
11. Power supply
12. Connector RJ45 Exit A
13. Connector RJ45 Exit B
Install the Light controller on a wall using the included mounting
template. Install the temperature sensor(s) which comes with a 4m long
cable at a point where you wish to undertake the measurement. Ensure that
this is not directly exposed to a heat source or stream of light in order to
obtain the best precise measurement of the ambient air as possible.
Connect the temperature sensor RJ45 connector with the Light controller
Temp in A or B.
Connect the power-supply to Light controller PWR and your mains.
The Light controller can be powered through the Exit A or B Lamp cable
powered from the LED-driver without the power supply!
Foreword
Warranty
Legend
Instructions
EN
17