Stove Operation; Starting The Stove; Modifying The Parameters; Switching Off - Palazzetti EASY TOUCH Uso Y Funciones

4 STOVE OPERATION

4.1 STARTING THE STOVE

Before every ignition, be sure that burning pot is completely empty and properly positioned in its seat.
To start the stove hold the
The 昀氀ame icon will start 昀氀ashing during the ignition stage until remaining on steady when the stove has started.
Automatic stove ignition: the stove comes with an automatic device that starts the pellet stove without using other
traditional 昀椀re lighters.
Avoid lighting the 昀氀ame manually if the stove's automatic ignition system is not working correctly.
When the stove is started the 昀椀rst time, unpleasant odours or smoke may be generated, caused by evaporation
or drying of certain materials used. This phenomenon will gradually disappear.
The room should be well ventilated when starting the stove the 昀椀rst few times.
"Sealed" series stoves
When opening the 昀椀rebox door, never leave it open too long, otherwise the door sensor will set o昀昀 the
open door signal (audible alarm).

4.2 MODIFYING THE PARAMETERS

The stove operating parameters can be modi昀椀ed as described.
The values set will be retained until next modi昀椀ed, even when the stove is switched o昀昀 or unplugged from the
power supply.

4.3 SWITCHING OFF

To switch the stove o昀昀 hold the
To start the stove again it's recommended to wait for the stove to cool down completely.
The stove should only be switched o昀昀 following the procedure described above. Never switch the stove o昀昀 by
unplugging it from the power supply.

4.4 OPERATION WITH ROOM THERMOSTAT

When the stove is controlled by an external thermostat (or timer thermostat) the installer must have set
Con昀椀guration 2. In this con昀椀guration the stove switches o昀昀 when reaching the external thermostat setting.
The stove switches on again automatically when the temperature falls below the value set on the external
thermostat (circuit closed).
On 昀椀rst ignition, or if the stove has been switched o昀昀 manually (
directly from the control panel.

4.5 OPERATION WITH ROOM PROBE ON THE STOVE

The stove can be switched on/o昀昀 manually or in programmed mode.
The stove modulates output according to the room temperature read by the probe on the stove (that is, the stove
attempts to maintain the desired temperature while minimising fuel consumption).
If the user has enabled the "Eco-mode" function , the stove rather than modulating its output, switches
o昀昀 when reaching the set temperature, and switches on again when the room temperature falls below
the delta set (see par. ).
The desired room temperature can be set in the temperature menu
button for several seconds.
button for a few seconds; the 昀氀ame icon will switch o昀昀.
004776500 - 11/12/2019
button), the stove needs to be started
.
23