Assemble again the screw and the locking nut.
Always use original CARAT spare parts (Art. 2009).
ADJUST THE CUTTING WHEEL BY TIGHTENING THE SCREW WITH A 3 MM MALE HEXAGONAL
WRENCH, UNTIL THE LATERAL BACKLASH IS REDUCED, AVOIDING ANY LOCKING.
ADJUSTMENT OF CUTTING CARRIAGE
• Remove any residues from the slide bar of the cutting carriage, without lubricating.
16
• Eliminate the lateral backlash of the carriage, by acting on the screw indicated in picture 14, using a 4 mm hexagonal
head wrench.
AN EXCESSIVE ADJUSTMENT WILL DAMAGE THE GOOD SLIDING OF THE CUTTING CARRIAGE.
CLEANING
Keep the slide bar clean using an all-purpose lubricant
DISPOSAL
In the event of scrapping the entire machine or part of it, it must be disposed of in accordance with the methods laid
down by current legislation.
Worktable
Carriage rod
Carriage
TROUBLESHOOTING
THIS TOOL MUST ONLY BE REPAIRED BY TRAINED PERSONNEL.
Repairs must be carried out by trained personnel only, using original spare parts, otherwise you may
cause considerable danger for the user.
Malfunctions not related to a conformity defect that exists at the time of purchase are excluded from the warranty.
Exclusions include:
-
Wear of materials (taking into account the average life of the product)
-
Failure to comply with the recommendations contained in this manual.
-
Maintenance and tampering carried out by unauthorized personnel.
-
Use of non-original spare parts.
EC DECLARATION OF CONFORMITY
CARAT NEDERLAND BV (Nikkelstraat 18, - 4823 AB Breda The Netherlands)
hereby declares under its sole responsibility that the PROFICOUP EVO product:
Series: FROFICOUP
Art: TAB 1
Model: herewith declares that the cutting machine for ceramic, single-firing ceramic, marble, gres, Klinker, Terracotta.
This Declaration relates to the following Directives: 2001/95/CE
Date of manufacture - Series N.
Aluminium
Steel
General Director
Kees Van Beek
Polyamide
11 11