Tabla de contenido
Idiomas disponibles
Idiomas disponibles
B
Using the appliance
Electrical connection
WARNING
Your machine is set to operate at 220-240 V. If the mains
voltage supply to your machine is 110 V, connect a
transformer of 110/220 V and 3000 W between the electrical
connection.
WARNING
Connect the product to a grounded outlet protected by a fuse
complying with the values in the «Technical Specifications»
table.
The earthed plug of the machine must be connected to an
earthed outlet supplied by suitable voltage and current.
In the absence of earthing installation, an authorised
electrician should carry out an earthing installation. In
the case of use without earthing installed, we will not be
responsible for any loss of use that may occur.
The plug on this appliance may incorporate 13A fuse
depending on the target country. (For example UK, Saudi
Arabia)
0.5 -
1.1m
8
EN
B
Using the appliance
Fitting the machine undercounter
If you wish to fit your machine undercounter, there must be sufficient space to do so and the
wiring-plumbing must be suitable to do so
for fitting your machine, remove the worktop as shown in the illustration
WARNING
The countertop, which the machine will be placed under,
must be stable in order to prevent imbalance.
The top panel of the dishwasher must be removed to fit the
machine under the countertop.
To remove the top panel, remove the screws that hold it on,
located at the rear of the machine. Then, push the panel
1 cm from the front towards the rear and lift it. Adjust the
machine feet according to the slope of the floor
Fit your machine by pushing it under the counter taking
care not to crush or bend the hoses
WARNING
After removing the top panel of your dishwasher, the
machine should be placed in a space of the dimensions
shown in the figure below.
1
. If the space under the countertop is suitable
.
2
.
3
.
4
9
EN
Tabla de contenido
