Operation; Assembly; Light Guide Connection - SCHOTT KL 300 LED Manual De Usuario

14

2. Operation

EN

2.1 Assembly

2.2 Light guide connection

The KL 300 LED can be mounted on all common microscopes or swing-arm
stands. Adapters are included with the light source or are available from the
dealers or manufacturer.
Insert the mounting adapter (A) into the receptacle on the underside of the light
source as far as it will go and tighten the two mounting screws (B) using an Allen
key (3 mm). You can now clamp the light source to the microscope or swing-arm
stand using the mounting adapter. Keep in mind, you may have to remove the
microscope body or the carrier beforehand and mount it again afterwards.
When using flexible light guides, the KL 300 LED can be laid flat on the work
surface, without a mounting adapter.
A
To install the light guide, push the light guide into the socket as far as it will
go. To ensure a tight fit and optimum illumination, the light guide must snap
into place. When inserting light guides with a guide pin, make sure that it is
alinged into one of the two slots.
To remove the light guide, pull it out of the light guide holder.
B