Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATING MODES: USB
A
-
Connect a USB storage device to the port on the rear panel of the speaker and select USB mode by
pressing MODE or via the APP*.
-
Playback can be controlled from the rear panel buttons
SONORA-5AWB
SONORA-5AWN
C
* if the speaker has been connected to Wi-Fi beforehand.
C
SONORA-5AWB
SONORA-5AWN
SONORA-5AWB
OPERATING MODES: AUX
SONORA-5AWN
C
SONORA-5AWB
SONORA-5AWN
B
C
SONORA-5AWB
SONORA-5AWN
-
Connect an auxiliary signal (PC, mixer, TV, etc.) to the AUX connector on the rear panel of the speaker
and select the AUX mode by pressing MODE or via the APP*.
* if the speaker has been connected to Wi-Fi beforehand.
WIRED CONNECTION TO A PASSIVE LOUDSPEAKER
-
FONESTAR recommends connecting a SONORA-4B or SONORA-4N to the R SPEAKER OUTPUT input
because it meets the technical specifications of this output. If you do not connect this model please note
the following:
- This output from this speaker (amplifier) is 25 W RMS @ 8 Ω.
- The impedance and power of the speaker we connect shall be greater than or equal to the
impedance and power of the output, 8Ω and 25 W RMS respectively.
- IMPORTANT: use the proper power, impedance and frequency limits for proper operation and
performance of the equipment. Before connecting to other equipment, be aware of the conditions
required in a LOW IMPEDANCE installation. More information can be found at:
fonestar.com/downloads/install_fonestar_es.pdf
CONNECTION
-
Install the speaker as described in the next section.
-
Optional: connect the AUX cable, USB device and/or positive speaker to the R SPEAKER OUTPUT.
-
Turn on speaker from the rear panel switch, select the operating mode and configure as required (APP,
volume, MONO/STEREO audio, etc).
USB MODE
USB MODE
C
AUX MODE
C
AUX MODE
SONORA-5AWB
SONORA-5AWN
SONORA-5AWB
SONORA-5AWN
,
and
SONORA-5AWB
SONORA-5AWN
SONORA-5AWB
SONORA-5AWN
- 5 -
or from the APP*.
EN
Tabla de contenido
