Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Mark holes
Select the vent option that your installation will require and
proceed to that section:
Outside top exhaust
(Vertical duct– 3 1 ⁄
"x 10" Rectangular)
4
Use the mounting template and mark the locations on the
cabinet for ductwork, electrical wiring and keyhole screw slots.
It is recommended to make the marks before the cabinet's
installation.
Cabinet
front side
A
Cabinet
bottom side
EE
B
D
system hole
C
F
CENTER
x
LINE
DIM
30"
36"
model
model
3 ⁄32" (1 cm)
A
7 1 ⁄2" (19 cm)
B
2 23 ⁄64" (6 cm)
C
4 21 ⁄64" (11 cm)
D
E
5
⁄
" (14 cm)
1
2
For recessed bottom cabinet only
If the cabinets have front, side or back trim, make 2 wood shims
the width of the trim and attach them to the cabinet bottom
recess on both sides.
Wood shims
Blower Installation
1.
Remove the grease filters.
2.
Disconnect the blower harness from the hood.
3.
Remove the blower mounting screws. Put the screws in a
safe place in order to use them again.
A
G
Mounting
screws (4)
H
J
Wood
shims
Vent
I
Wiring access knockout
(cabinet bottom side)
DIM
30"
36"
model
model
6 ⁄8" (2 cm)
F
2 3 ⁄4" (7 cm)
G
1 7 ⁄8" (4.7 cm)
H
5 7 ⁄8" (15 cm)
I
J
1" (2.54 cm)
A. Blower
B. Blower screws
B
4.
Set free the two blower springs from the top of the range
hood housing.
5.
Cut the blower harness plastic and extend the wire.
6.
Flip the blower base to the rear face of the range hood.
7.
Insert the two blower springs to the top of the range hood
housing, secure it with the four mounting screws previously
released.
Cabinet Installation
NOTE: Your cabinet must be able to support at least 88 lb (40 kg).
1.
Drive a mounting screw (from the hardware package) partway
into each center of the narrow neck of the keyhole slots
marked on the cabinet bottom.
2.
Install the 4 - 4 x 8 mm mounting screws. Leave a
(6.4 mm) gap between the wall and the back of the screw
head to slide range hood into place
3.
Fix the wiring conduit of the hood.
4.
Slide the hood back against the cabinet. Tighten the
mounting screws. Be sure the screw heads are in the narrow
neck of the keyhole slot.
5.
Drive 2 pieces of the selected security screws in the lower
security screws location (see the image below).
A
A. 4- 4x8 mm mounting screws
6
⁄
1
4
⁄
" (6.4 mm).
1
4
B. Round washers
C. Security screws
"
Tabla de contenido
