Rules For Safe Operation - Craftsman WEEDWACKER 316.795861 Manual Del Operador

• Always stop the engine and allow it to cool before filling the fuel tank.
Never remove the fuel tank cap or add fuel when the engine is hot. Always
loosen the fuel tank cap slowly to relieve any pressure in the tank before
fueling. Do not smoke.
• Always mix and add fuel in a clean, well-ventilated outdoor area where
there are no sparks or flames. Do not smoke.
• Never operate the unit without the fuel cap securely in place.
• Avoid creating a source of ignition for spilled fuel. Wipe up any spilled fuel
from the unit immediately before starting the engine. Move the unit at least
30 feet (9.1 m) from the fueling source and site before starting the engine.
Do not smoke.
• Never start or run the unit inside a closed room or building. Breathing exhaust
fumes can kill. Only operate this unit in a well-ventilated outdoor area.
• Check the unit for fuel leaks.
• Loosen the fuel tank cap slowly to relieve any pressure in the tank.
• Never store the unit with fuel in the tank, inside a building where fumes
may reach an open flame (pilot lights, etc.) or sparks (switches, electrical
motors, etc.).
• To reduce fire hazard, replace a faulty muffler and spark arrestor. Keep the
engine and muffler free from grass, leaves, excessive grease or carbon
build up.
• Avoid accidental starting. Be in the starting position whenever pulling the
starter rope. The operator and unit must be in a stable position while starting.
• Do not touch the engine, gear housing or muffler. These parts get
extremely hot from operation, even after the unit is turned off.
• Turn the engine to off and disconnect the spark plug for maintenance or
repair.
TRIMMER SAFETY
• The trimmer attachment shield must always be in place while operating
the unit. Do not operate unit without both trimming lines extended, and
the proper line installed. Do not extend the trimming line beyond the
length of the shield.
• Adjust the D-handle that provides the best possible grip.
• Be sure the trimmer attachment is not in contact with anything before
starting the unit.
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for
complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING
• SAFETY ALERT SYMBOL
Indicates danger, warning or caution. May be used in
conjunction with other symbols or pictographs.
• READ OPERATOR'S MANUAL
WARNING:
Read the operator's manual(s) and follow all
warnings and safety instructions. Failure to do so can result
in serious injury to the operator and/or bystanders.
• WEAR EYE AND HEARING PROTECTION
WARNING:
Thrown objects and loud noise can cause
severe eye injury and hearing loss. Wear eye protection
meeting ANSI Z87.1-1989 standards and ear protection when
operating this unit. Use a full face shield when needed.
• UNLEADED FUEL
Always use clean, fresh unleaded fuel
• DO NOT USE E85 FUEL IN THIS UNIT
WARNING:
It has been proven that fuel containing greater
than 10% ethanol will likely damage this engine and void the
warranty.
• ON/OFF STOP CONTROL
ON / START / RUN
• ON/OFF STOP CONTROL
OFF or STOP
• OIL
Refer to operator's manual for the proper type of oil.

RULES FOR SAFE OPERATION

• Use only Hassle Free™ XTRA QUIET Spiral Line replacement line. Never
use metal-reinforced line, wire, chain or rope. These can break off and
become dangerous projectiles.
• Keep unit clean of vegetation and other materials. They may become
lodged between the trimmer attachment and shield.
• Keep hands, face, and feet away from all moving parts. Do not touch or
try to stop the trimmer attachment when it rotates.
BRUSHCUTTER SAFETY
• Always use the shoulder harness when using the brush blade accessory.
• Keep the handle between the operator and cutting attachment or blade at
all times.
• NEVER cut when the cutting blade is 30 inches (76 cm) or more above the
ground level.
• Blade thrust may occur when the spinning blade contacts an object that it
does not immediately cut. Blade thrust can be violent enough to propel the
unit and/or operator in any direction, possibly causing a loss of control. Blade
thrust can occur without warning if the blade snags, stalls or binds. This is
more likely to occur in areas where it is difficult to see the material being cut.
• For operation with the brush blade, do not cut anything thicker than 1/2
inch or a violent kickback could occur.
• A coasting blade can cause injury while it continues to spin after the
engine is stopped or the throttle trigger is released. Maintain proper
control until the blade has completely stopped rotating.
• Do not operate unit with a bent, cracked or dull blade. Discard blades that
are bent, warped, cracked or broken.
• Do not sharpen the cutting blade. Sharpening the blade can cause the
blade tip to break off while in use. This can result in severe personal injury.
Replace the blade.
• Do not use the cutting blade for edging or as an edger; severe personal
injury to yourself or others may incur. Use the cutting blade only for the
purpose described in this manual.
• Stop the engine IMMEDIATELY if there is excessive vibration. Vibration is a
sign of trouble. Inspect thoroughly for loose nuts, bolts or damage before
continuing. Repair or replace affected parts as necessary.
• SAFETY & INTERNATIONAL SYMBOLS •
SYMBOL
3
SAVE THESE INSTRUCTIONS
MEANING
• PRIMER BULB
Push primer bulb, fully and slowly, 10 times.
• KEEP BYSTANDERS AWAY
WARNING:
Keep all bystanders, especially children and
pets, at least 50 feet (15 m.) from the operating area.
• HOT SURFACE
WARNING:
Do not touch any metal engine components.
The engine gets extremely hot from operation and may cause
severe burns. Allow the unit to completely cool prior to any
maintenance or servicing.
• THROWN OBJECTS AND ROTATING CUTTER CAN
CAUSE SEVERE INJURY
WARNING:
Small objects can be propelled at high speed,
causing injury. Keep away from the rotating rotor.
• SHARP BLADE
WARNING:
Sharp blade on trimmer attachment shield. To
prevent serious injury, do not touch the line cutting blade.
• BRUSHCUTTERS - REPLACE DULL BLADE
Do not sharpen the cutting blade. Sharpening the blade can
cause the blade tip to break off while in use. This can result
in severe personal injury.
• TRIMMER/ BRUSHCUTTER SAFETY
WARNING:
Thrown objects and rotating cutter can cause
severe injury. Keep bystanders, especially children and pets,
at least 50 feet (15 m) away from the cutting area. The cutting
attachment shield must be used when using the trimmer
cutting attachment.