Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
Duct
Attaching part
WARNING
Prior to the sanding operation, make sure the
material of surface you are going to sand.
If the surface under sanding operation is
expected to generate harmful / toxic dusts such
as lead painted surface, make sure the dust
bag or appropriate dust extraction system is
connected with dust outlet tightly.
Wear the dust mask additionally, if available.
Do not inhale or touch the harmful / toxic dusts
generated in sanding operation, the dust can
endanger the health of yourself and bystanders.
CAUTION
If too much dust accumulates in the dust bag,
the dust collection power will be reduced.
Dispose of dust as soon as possible.
6. Attaching and Removing the Elbow (Fig. 11)
Attach the elbow to the duct before use. Adjust the
angle of the elbow so that the dust is discharged
away from your body.
Duct
16
Dust bag
Fig. 10
Attaching part Elbow
Fig. 11
7. About the mode change function
The unit has "Transmission mode" and "Auto mode".
○ With Transmission mode, the belt sander's number of
revolutions can be set at one of fi ve stages.
When operating in Transmission mode, the set
number of revolutions will be maintained regardless
of changes in load.
○ With Auto mode, you can lower noise and vibration by
lowering the maximum number of revolutions while in
a no-load state.
While in Auto mode, the number of revolutions will be
raised if the load becomes greater during operation.
On the other hand, the number of revolutions will
be lowered if the load decreases during operation.
(Table 5)
○ Set the mode using the dial according to work
application (Fig. 12)
Dial setting
1
2
3
4
5
A
1,475 ft/min (With load)
8. Check battery insertion
CAUTION
Until the battery locks in place with a little click,
if not, it may accidentally fall out of the tool
causing injury to you or someone around you.
OPERATION
WARNING
● Be sure to turn off the switch, then remove the
battery from the tool in the following situations:
• When stopping or ending work
• When attaching or removing accessories or
optional parts
• When maintaining, inspecting, or storing the
tool
Table 5
Belt speed
400 ft/min
710 ft/min
1,020 ft/min
1,320 ft/min
1,475 ft/min
400 ft/min (No load)
Dial
Fig. 12
Tabla de contenido
