Maintenance, Cleaning, Storage; Maintenance And Cleaning; Troubleshooting - SPORTSTECH VX350 Manual De Instrucciones

7. Maintenance, cleaning, storage

7.1 MAINTENANCE AND CLEANING

• Immediately after training, switch the device off, and unplug it.
• After training, remove sweat from the device and its remote control with a dry or slightly wetted cloth.
Never use agressive cleansers. Never let any humidity enter a housing.
• Make sure the Product label stickers and, if available, others are attached and readable.
7.2 STORAGE
• Allow the device to cool down sufficiently before placing it in the protective cover, a transport container or
a cabinet.
• The storage site of the device must fulfill these requirements:
- Dry and clean indoor area, free from explosive or flammable substances and dust.
- Temperature within permitted range for operation (see technical data).
- No direct sunlight.
• For longer storage, protect the device against dust.

8. Troubleshooting

Error
Device does not start
Louder operating noise
The remote control
does not work.
Device stops during
use.
Normal function not
possible.
With heating
function, device
becomes very warm
Error message 'E1'
Error message 'E2'
or 'E3'
Contact customer service if any problems or doubts persist.
22
Possible reason
Cables not connected correctly
Fuse has tripped.
Device is standing on hard ground.
Device is not horizontal.
Batteries are empty.
Distance or angle too large or sensor
covered
Functional duration of 10 minutes
achieved.
Control overloaded
Device used for too long
Overload of the vibrating surfaces
(over 40 kg (88 lb))
Computer error
Possible solution
Connect both cables correctly
Switch the fuse on again or have it replaced
Place the device on a surface.
Align the device horizontally.
Replace the batteries.
Hold the remote control with "visual contact"
less than 2 m in front of the device.
Take a break.
Disconnect the power supply and restart
the device.
Take a break; let cool down.
Relieve the vibrating surfaces and restart
the device.
• Disconnect power supply and restart
device; otherwise:
• Contact customer service.