Troubleshooting; Notes - Truper ENNE-160 Manual

Problem
Air leak in the upper
side of the tool or in
the trigger area.
The tool is not
operating or goes to
slow.
Leak in the lower
side of the tool.
The tool gets blocked
frequently.
Other problems.
10
ENGLISH
Cause
• Loose screws.
• Worn "O"-rings or damaged seals.
• Inadequate air supply.
• Inadequate lubrication.
• Worn "O"-rings or damaged seals.
• Loose screws.
• Worn "O"-rings or damaged seals.
• Wrong staples.
• Damaged staples.
• Loose cartridge or nozzle screw.
• Dirty cartridge.
• The shooting mechanism is damaged or worn.
• Diverse reasons.

Troubleshooting

Solution
• Fasten all the screws.
• Go to a
Center to replace the parts.
• Regulate the air feeding pressure.
• Lubricate following instructions indicated in this
manual.
• Go to a
Center to replace the parts.
• Fasten all the screws.
• Go to a
Center to replace the parts.
• Check the staples have the right size.
• Replace with staplers in good repair.
• Fasten the screws.
• Clean the cartridge.
• Go to a
Center to replace the parts.
• Go to a
Center to replace the parts.

Notes

Authorized Service
Authorized Service
Authorized Service
Authorized Service
Authorized Service