VONROC EH519AC Traducción Del Manual Original página 7

shows flashing "01" for 4 times, then the
screen reverts to showing the current ambient
temperature.
- High heating mode – 1500W: the high heating
indicator (3C) will light up. The display(4)
shows flashing "02" for 4 times, then the
screen reverts to showing the current ambient
temperature.
Functions of the remote control (Fig. C)
In addition to the before mentioned control panel
operation, the heater can also be operated by the
remote control (9). The available functions are:
• On/off button (9A): Turns the heater on and off.
• Mode button (9B): Cycles between fan, low and
high heating.
- Fan: The fan indicator (3A) will light up.
- Low heating mode – 1000W: the low heating
indicator (3B) will light up. The display (4)
shows flashing "01" for 4 times, then the
screen reverts to showing the current ambient
temperature.
- High heating mode – 1500W: the high heating
indicator (3C) will light up. The display (4)
shows flashing "02" for 4 times, then the
screen reverts to showing the current ambient
temperature.
• Timer button (9C): The timer can be set
between 1 hour and 12 hours. Press the timer
button (2B) to set the timer with 1 hour
intervals. The display (4) shows the duration
currently set for 5 seconds. The timer indicator
(3D) will light up. Without a timer there is no
limit.
• Oscillation button (9F): Press the oscillation
button to activate the heater to swing. The
oscillate indicator (3E) will light up. Press it
again to deactivate.
• Temperature increase button (9D): Press to
increase the desired ambient temperature.
• Temperature decrease button (9E): Press to
decrease the desires ambient temperature.
Tip-over switch (8)
This heater has an mechanical tip-over protection.
This protection ensures when the heater is not
placed upright on a firm and level surface or when
the heater tip over, the system will automatically
shut the heater off. If this occurs, put the heater on
a firm and level surface and start the heater again.
WWW.VONROC.COM
Automatic Overheat Safety Control
This heater is equipped with safety internal heat
limiting thermostat and overheat protection circuit.
When a potential overheat temperature is reached,
the system will automatically shut the heater off.
If this occurs, the heater can only resume after
resetting it. To reset the heater: Unplug the heater
and wait at least 30 minutes to cool down before
restarting the heater.
Stopping the electric heater (Fig. A, B)
Let the machine cool down before turning
off by using the ventilation function.
• Press the on/off and mode button (2D) until the
fan indicator (3A) starts to flash.
• The fan mode will start and will cool down the
heater for 15 seconds. The display will show the
duration.
• Pull the plug out of the mains power outlet.
Storing the electric heater
• Always let the heater cool down completely
before storing the machine.
• Never wrap the cable around the heater
Warning! Never store the machine in a wet
or dusty environment
4. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Cleaning
Let the machine cool down completely
before cleaning.
• Clean the heater with a (lightly damp) cloth,
brush or vacuum cleaner.
• In order to protect the enclosure, don't splash
water onto the heater, and never use a solvent
like gasoline, isoamyl acetate, toluene, etc. to
clean the heater.
• Clean the air inlet and outlet (6, 7) regularly
with a vacuum cleaner.
• When you store the heater, let it cool down first
and, keep it dry.
EN
7