Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Stage One – Rapid Start Charge delivers maximum charging amperage to "wake up" any
serviceable 12 volt battery and allows for quick engine starting in just 5 minutes (based
on a midsize vehicle battery at 50% charge level). When battery reaches a maximum safe
predetermined voltage, the charger will automatically signal a "beep" and move into Stage
2 of the charging process. At the end of Stage 2, the charger will signal a BEEP and move
into Stage 3 charge mode.
Stage Two – Absorption Charge maintains the maximum possible charge at a constant,
safe, predetermined voltage. During the phase, voltage absorption regulation charge, the
charging voltage remains constant, while the actual charging current is reduced to allow
for the maximum proper internal chemical energy transfer.
Stage Three – Top-Off Charge voltage is automatically maintained and reduced to a pre-
determined level while current is adjusted for a safe, effective battery charge level (step-
down regulation mode); ideal for topping off batteries that have been in storage. At the
conclusion of Stage 3, the unit will BEEP signaling the completion of the charging cycle.
The Automatic Float Charge feature is ideal for maintaining a battery. It automatically
tops off a battery as needed, to keep it fully charged all the time.
Figure 2. Charge Curve
STAGE ONE
BEEP
FEATURES
• This unit has three charge rate settings, with a 2/10/25 amp push button charge rate
switch:
a) 2 amps: smaller batteries, as in lawn mowers, snowmobiles, motorcycles, etc.
b) 10 amps: middle-sized batteries, such as in small cars
c) 25 amps: automobile batteries and light trucks
• Automatic temperature compensation
• Battery type selection
• Digital diagnostics
• Alternator voltage and battery check
• Digital display shows charge rate, operating
mode, fault codes and FUL when charged
• 1 minute engine start
• 3 stage high frequency switch mode
automatic rapid charging
• Spark-resistant reverse polarity
and short circuit protection for user
BEEP
STAGE TWO
STAGE THREE
OFF BEEP
• Built-in battery reconditioning
(desulfate)
• Lightweight, high efficiency design
• Internal short circuit protection
• Cables and clamps self-stored
• Reverse polarity indicator
• Microprocessor control (Digital
Smart Control) / high frequency
power
• Compensates for low AC from
extension cord use
• Equalization function
– 5 –
CHARGING
COMPLETE
Tabla de contenido
